hiller-manufacture,factory,supplier from China

1BQD Series Opposed disc harrow is mainly for the cleaning stubble before tillage,breaking the hardened surface ,soil pulverization and leveling   ModelUnit1BQD-1.61BQD-2.01BQD-2.4Working widthmm160020002400Working depthmm140Q’ty of disc162024Total weightkg460490520  Matched   powerhp304050-60LinkageThree-point suspension   I typeThree-point suspension   II type

Install bridge bearings on the half shaft to attenuate vibration and protect the half shaft and other components.The half shaft (drive shaft) is subjected to alternating stresses such as torsion, shear, tension and compression, and impact, which can also cause torsional and bending vibrations of the drive shaft, resulting in additional stresses; Uneven stress distribution; There is sliding friction between the drive shaft neck and the bearing.The shaft that transfers torque between the half shaft gearbox reducer and the drive wheel (previously mostly solid, but due to the easier control of une

1.In general, the efficiency of using axle bearings is similar to that of power and lubrication bearings, but the rocker arm hybrid lubrication bearings are much higher.2. The radial clearance of the axle bearing is relatively small, and the radial angular contact bearing can be pre tightened with pre tightening force to eliminate the clearance, resulting in high performance during operation.Compared to bearings of the same type, axle bearings have a smaller width and a compact structure.4.

1LY Disc plough is specially designed , manufactured and borrowed according the features of foreign disc plough, it is  Fully-suspended with four wheel tractor. And the discs are rotary motion when tuning the soil. This mounted disk plow is especially suitable for cultivation in the land with weeds, stems and frictional soil with bricks.Modelunit1LY-21LY-31LY-41LY-5Working widthmm60090012001500Working depthmm250~300Q’ ty of disc2345Total weightkg350400470560Matched powerhp406080120LinkageThree-point suspension II type

Disc harrow is mainly applicable to clean the crop residue before tillage, break the hardened a break the hardened soil and  return the chopped straw to the soil, and  also can crash the soil after tillage and level the land.This tractor disc harrow can be used as tillage machine instead of plow on the cultivated land. With the efficient productivity, reasonable utilization of the power, great ability of cutting and shattering the soil , the soil surface is smooth and loosening after harrowing, it is well suitable for heavy clay soil, waste land and weedy field as well.

Disc harrow is mainly applicable to clean the crop residue before tillage, break the hardened soil and  return the chopped straw to the soil, and  also can crash the soil after tillage and level the land.It can be used as tillage machine instead of plow on the cultivated land.

1LF hydraulic reversible plow is mounted with four-wheel tractor; it is used for the loam,sand loam , cultivated and dry land ,it can finish the furrowing work in double way.Model1LF-3301LF-4301LF-5301LF-3351LF-4351LF-535Working widthmm90012001500105014001750Working depthmm220-270Number of bottoms68106810Total weightkg5807509506208001000Matched powerhp507080557590LinkageThree-point suspension II type ,hydraulic output(difunctional oil cylinder),oil connection in 1/2” thread

3Z cultivator is suitable for cultivating corn, cotton, soybean, sugar beet, etc. It can perform cultivating, ditching, riding, deep loosing, etc. The rotary cultivator can break the harden soil, loose soil, and keep the underground water of soil, and clean the stubble of crop. This cultivating machine  is rational structure. It is safe, durable, and high efficiency. Modelunit3Z-23Z-33Z-43Z-5Working widthmm1100190029003700Working depthmm100-200No.

Disc plough is matched with four-wheel tractor, the discs of plough are revolving to furrow the land during operation.. The mounted disc plow is especially suitable for land which have weeds, stems and frictional soil with small brick etc.Modelunit1LYX-2301LYX-3301LYX-4301LYX-530Working widthmm60090012001500Working depthmm250~300Q’ ty of disc2345Total weightkg300440490550Matched powerhp4060100130LinkageThree-point suspension II type

Disc harrow is mainly applicable to clean the crop residue before tillage, break the hardened soil and return the chopped straw to the soil, and  also can crash the soil after tillage and level the land.It can be used as tillage machine instead of plow on the cultivated land. With the efficient productivity, reasonable utilization of the power, great ability of cutting and shattering the soil , the soil surface is smooth and loosening after harrowing, it is well suitable for heavy clay soil, waste land and weedy field as well.

3QL series ridger plough is mainly suitable for ridging after the tillage in the field for potato, beans, vegetables etc. it is convenient to adjust the angle, the high ridge and the ridging rows. It can be easily spaced (widened or narrowed) as per the crop requirement. The wings angle can be changed as per requirement.ModelUnit3QL-33QL-43QL-5Working widthMm250032003900Ridging spacingMm700~900Ridging heightMm150~250Matched powerHp6080100LinkageThree-point suspension II type

1)Wet cylinderThe location bores and particularly the running surfaces in the cylinder block must be cleaned carefully and they must be undamaged. Corroded surfaces must be reworked (used flange liners and outer diameter oversize liners). As this is done, make sure that the liners moves in easily and that they take up the correct position (the projecting length of the liner must be in accordance with the regulations of the engine manufacture).

The half shaft is used to transfer power between the differential and the drive wheels. The half shaft of a regular non disconnecting drive axle can be divided into three types: fully floating, 3/4 floating, and semi floating depending on the external support form.Expand the information on car drive shafts and design a transmission device for driving wheels located at the end of the car's transmission system. Its function is to transmit torque from the differential half shaft gear to the driving wheels.

1LF hydraulic reversible plow is mounted with four-wheel tractor; it is used for the loam,sand loam , cultivated and dry land ,it can finish the furrowing work in double way.Model1LF-3301LF-4301LF-5301LF-3351LF-4351LF-535Working widthmm90012001500105014001750Working depthmm220-270Number of bottoms68106810Total weightkg5807509506208001000Matched powerhp507080557590LinkageThree-point suspension II type ,hydraulic output(difunctional oil cylinder),oil connection in 1/2” thread

1LY(SX) Series Hydraulic reversible disc plough is matched with four wheel tractor, the discs of plough are revolving to furrow the land during operation.,it can come true the plowing work in double way. Especially suitable for the operation in the  land which have the weeds, stems, frictional soil , small brick . Modelunit1LY(SX)-3251LY(SX)-4251LY(SX)-525Working widthmm75010001250Working depthmm250~300Q’ty of disc345Total weightkg600720820Matched powerhp5090-120130-150LinkageThree-point suspension II type; hydraulic output ( difunctional oil cylinder; o

this rear mounted rotary mower is the updated version from the type 9GX series.we add the chain in the front and rear of the tractor rotary slasher to protect the worker.

The main function of bearings is to support the mechanical rotating body, in order to reduce the mechanical load friction coefficient of the equipment during the transmission process. Bearings are components that fix and reduce the load friction coefficient during mechanical transmission.

This mounted land scraper is a farm implements that uses the scraper which fitted between the front and back rear wheels to unknit land, the scraper can be lifted, sloped, revolved and extended.this machine is  Flexible and accurate, easy to use; applicable for constructing the roadbed and road surface, ditching the side slope, mixing road mixtures, removing snow, transporting grain materials and maintaining the dirt roads and gravel roads, etc.

This mounted land scraper is a farm implements that uses the scraper which fitted between the front and back rear wheels to unknit land, the scraper can be lifted, sloped, revolved and extended.this machine is  Flexible and accurate, easy to use; applicable for constructing the roadbed and road surface, ditching the side slope, mixing road mixtures, removing snow, transporting grain materials and maintaining the dirt roads and gravel roads, etc.

Model9GDM-1.259GDM-1.359GDM-1.65Tractor power required (HP)25-4035-5045-60Cutting width (m)1.251.351.65Quantity of drum disc222Work efficiency (km/h)151515Quantity of blades 666Cutting blade size (mm)47*100*347*100*347*100*3Cutting blade material 65Mn65Mn65MnPTO rotation speed (r/min)540540540Drum rotation speed (r/min)162016201620Overall dimension （mm)2300*800*10502400*850*10503000*900*1100Weight（Kg）330350448

Series of 9GX Mainly applicable for grassland, shrub land and field with rough surface. It Uses offset brace linkage machine to drive knife. Mainly applicable for farm land, field grassland, mountains, natural grazing and planted grazing. With reasonable structure; simple and reliable to use, etc. ModelUnit9GX-0.89GX-1.59GX-1.89GX-2.1Working widthmm800160018002100Working depthmm30-50PTO Rotation speedr/min540PTO shaft spline6 spline or 8 splineTotal weightkg220335440520Matched powerhp20-4040-6070-8090LinkageThree-point suspension 

Product Description:This mounted land scraper is a farm implements that uses the scraper which fitted between the front and back rear wheels to unknit land, the scraper can be lifted, sloped, revolved and extended.this machine is  Flexible and accurate, easy to use; applicable for constructing the roadbed and road surface, ditching the side slope, mixing road mixtures, removing snow, transporting grain materials and maintaining the dirt roads and gravel roads, etc.